07-01-2017, 10:02 PM
(This post was last modified: 07-01-2017, 10:03 PM by Rippthrough.)
Takes way too long to print one to get that in at a tenner, even for an FDM printer with a lower quality print.
The best way would be to have a male and female mould printed, prepped and then fibreglass 'em, but that's only worth it if you have 20+ people.
The best way would be to have a male and female mould printed, prepped and then fibreglass 'em, but that's only worth it if you have 20+ people.
Custom roll cages/shiny suspension bits/general fabrication work undertaken, PM me.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.
Top engine mount repair/reinforcement/chocking for cracked chassis and high powered cars, drive in, drive out, 2 hour turnaround.