27-10-2014, 02:01 PM
(This post was last modified: 27-10-2014, 02:08 PM by londondan86.)
Dunno why it did that??? Sorted anyway!
Most important thing is I have a rev counter!!! Lol
Got to have a look at the legality of using my trade plates to take it for a test run now.
My next task for this week. Get this block striped down and off to the machine shop with the head and valves
[attachment=19797]
My new linkage that got knocked up to stop it fowling on the manifold
[attachment=19798]
The burnt loom
[attachment=19799]
Also needing some shells and piston rings. Any recommendations on where to go/prices etc. The shells are for hdi style sputter rods btw
Most important thing is I have a rev counter!!! Lol
Got to have a look at the legality of using my trade plates to take it for a test run now.
My next task for this week. Get this block striped down and off to the machine shop with the head and valves
[attachment=19797]
My new linkage that got knocked up to stop it fowling on the manifold
[attachment=19798]
The burnt loom
[attachment=19799]
Also needing some shells and piston rings. Any recommendations on where to go/prices etc. The shells are for hdi style sputter rods btw