19-05-2016, 12:35 PM
Thanks for all the replies guys, need to get this sorted now really.
Guys thoughts:
So without sounding like a douche bag, how do I check the coil and injectors have a good power supply? I'm very noob when it comes to wiring / electricals so it's all new to me.
I've looked at these from: http://www.306gti6.com/forum/showthread....340&page=1
My coil wiring is different to this right so what am I prodding where with my multimeter to check for power supply whilst cranking?
Here's few pics of the bay / plugs / etc.
The bay:
Injectors plug 1:
Coil pack plug:
Wiring going to Relays & Omex:
Relays for coils, injectors, lambda, fans, have tried switching these around, no difference, are working fine.
Guys thoughts:
Quote:6v is a little low, however, the ECU is live because Run Time is counting and is receiving the correct signal from the crank sensor, Engine Speed is showing a correct value and Stat Sync’d is going ON. Providing the calibration is correct this means the ECU is operating its outputs so I would advise you to check the coil and injectors have a power supply whilst cranking the engine.
So without sounding like a douche bag, how do I check the coil and injectors have a good power supply? I'm very noob when it comes to wiring / electricals so it's all new to me.
I've looked at these from: http://www.306gti6.com/forum/showthread....340&page=1
My coil wiring is different to this right so what am I prodding where with my multimeter to check for power supply whilst cranking?
Here's few pics of the bay / plugs / etc.
The bay:
Injectors plug 1:
Coil pack plug:
Wiring going to Relays & Omex:
Relays for coils, injectors, lambda, fans, have tried switching these around, no difference, are working fine.