30-03-2017, 05:23 PM
(28-03-2017, 12:21 PM)wainwrightj Wrote:(28-03-2017, 12:11 PM)Frosty Wrote: How far from taunton are you? Give me a shout when you get the beam apart and i'll see what i can sort out for you.
Only about 40 minutes so would be an ideal place to meet if it's close enough for you?
I'm about 20mins from Taunton so it's not too bad.
(30-03-2017, 04:33 PM)wainwrightj Wrote: Didn't really plan on having to bump this but I'm still un-sure on how hard it is to set the height of a beam whilst it's off the car?
If I remove the torsion bars is it as simple as putting blindly putting them back or do they have to be put back in a specific way, I understand that the bars are left and right.
Think some people have made up dummy shocks and do it that way. When I did one few months back we measured the beam that was on there from the hub to the arch and then fitted the new beam tube to the car and then built the beam up on the car with measuring the distance when fitting the trailing arms before sliding the torsion bars in after selecting the height we wanted.