08-10-2017, 06:41 PM
Right, been a while! so a little update.
Should be getting my rods at some point in the week, then at least i'll be able to start rebuilding on the bottom end, once thats done I can measure piston potrusion and order a head gasket, then rebuild top end. Should have my cylinder head back shortly as well, they've had it for a few months now! chasing them up this week.
Currently in the process of getting quotes for shot peening the gearsets, as i my budget doesnt currently allow for a drenth straight cut set
subframe is all cleaned up and ready to go, apart from I had to cut off one of the cups on the front mounting point, and cant seem to find a new one anywhere!!
Still a lot of wiring to get through too... I hate wiring...
Should be getting my rods at some point in the week, then at least i'll be able to start rebuilding on the bottom end, once thats done I can measure piston potrusion and order a head gasket, then rebuild top end. Should have my cylinder head back shortly as well, they've had it for a few months now! chasing them up this week.
Currently in the process of getting quotes for shot peening the gearsets, as i my budget doesnt currently allow for a drenth straight cut set
subframe is all cleaned up and ready to go, apart from I had to cut off one of the cups on the front mounting point, and cant seem to find a new one anywhere!!
Still a lot of wiring to get through too... I hate wiring...