11-08-2015, 08:59 PM
Any Ph2 onwards XUD/DW8 loom should work absolutely fine.
Although no need to fart about using the DW8 loom as that has all the advance ECU bullshit in it - a Ph2 XUD loom would be your best bet IMHO.
Only thing that MIGHT need changing from memory is to use a solenoid feed from the glowplug relay, but it's not difficult - all the starter pins, speed sense pins, oil pressure etc pins all work fine, from memory you'd need to just swap a temperature sensor out for the Bitron unit which is diff on Ph3, but then it should work. I basically did precisely this conversion with mine (just that I actually used an XUD, but same theory applies) just plugged in my old Ph2 loom and other than rev counter on the Ph3 clocks, from memory it just worked.
Although no need to fart about using the DW8 loom as that has all the advance ECU bullshit in it - a Ph2 XUD loom would be your best bet IMHO.
Only thing that MIGHT need changing from memory is to use a solenoid feed from the glowplug relay, but it's not difficult - all the starter pins, speed sense pins, oil pressure etc pins all work fine, from memory you'd need to just swap a temperature sensor out for the Bitron unit which is diff on Ph3, but then it should work. I basically did precisely this conversion with mine (just that I actually used an XUD, but same theory applies) just plugged in my old Ph2 loom and other than rev counter on the Ph3 clocks, from memory it just worked.
