Dr_Jekyll & Mr_Hyde Estate Project

[dr_jekyll]

speak to Stew kindly - I'm sure they have revised the design now - my replacement is still going strong

Hes working on a prototype similar to vibras design. Waitingbto hear back from him about one

sweet

I've edited my post - I haven't seen a lot go, just a few, maybe 4 or 5 and Baker BM have been right helpful in providing replacements free of charge and offering advice.

welshpug is on the money, not having them tight or running without the washer can certainly lead to this on any type of cup mount

Was running the washer. The mount actually pulled the chassis out first time but the reinforcment may have killed it.

Ive not got a bad word to say about bakerbm, they are liturally one of the most helpful companies ive dealt with.

Am i right in thinking to get the hdi inlet manifold off you have to have the exhaust off first? Been donks since ive done it. Got four bolts out the inlet so far and 6 out the exhaust but rained off again -.-