Bought a powerflow back box to fit to the eatate. Problem with the estates is the fact there exhausts finish inder the car and I was after abit of visible smoke.
[attachment=15284]
Because theres no hangers at the back of the car the first job was to add a hanger in.
[attachment=15285]
Once the hanger was in I was able to make a pipe to extend off the original. This meant that if I ever wanted the standard back box back on I could no problems once the pipe was made it was a simple case of hanging the exhaust.
[attachment=15286]
as the car was low I wanted the exhaust as close to the bumper as possible. As most people know when you get the exhaust to close to the bumper it melts. My solution to this was to fit some heat shielding that is usually found on the inside of motorcycle plastics near the exhaust.
[attachment=15287]
and boom, estate with a cheeky pipe
[attachment=15288]
[attachment=15284]
Because theres no hangers at the back of the car the first job was to add a hanger in.
[attachment=15285]
Once the hanger was in I was able to make a pipe to extend off the original. This meant that if I ever wanted the standard back box back on I could no problems once the pipe was made it was a simple case of hanging the exhaust.
[attachment=15286]
as the car was low I wanted the exhaust as close to the bumper as possible. As most people know when you get the exhaust to close to the bumper it melts. My solution to this was to fit some heat shielding that is usually found on the inside of motorcycle plastics near the exhaust.
[attachment=15287]
and boom, estate with a cheeky pipe
[attachment=15288]
Still Living For The 306
306 Ph1 Dturbo Estate
205 1.9 GTI (Rust.In.Pieces)
306 HDI Stage 3 Estate (Rust.In.Pieces)
306 Ph1 Dturbo Estate
205 1.9 GTI (Rust.In.Pieces)
306 HDI Stage 3 Estate (Rust.In.Pieces)