17-06-2014, 12:32 AM
The map sensor that was originally on the car was only a 2.5 bar sensor, so only good for 1.5 bar boost, managed to get a 3 bar map sensor today so can now run 2 bar of boost
Just need to fine tune the boost map now and all is sorted
Just in time to go on the dyno on Friday
Now that's is finally running correctly I can start tidying up the engine bay and look at getting rid of the really annoying exhaust rattle which has developed since taking the engine out and putting it back in!
Also need to remove the mid box and get a smaller back box, possibly thinking of a twin tip as it will fill the cut out in the bumper nicely
Just need to fine tune the boost map now and all is sorted
Just in time to go on the dyno on Friday
Now that's is finally running correctly I can start tidying up the engine bay and look at getting rid of the really annoying exhaust rattle which has developed since taking the engine out and putting it back in!
Also need to remove the mid box and get a smaller back box, possibly thinking of a twin tip as it will fill the cut out in the bumper nicely