21-11-2012, 04:54 PM
Turbos shat itself, compressor housing has bent the retaining washers On one side and pulled itself about 3mm from the cartridge. Not had time to investigate properly but the comp wheel/shaft don't seem so straight any more.
Think it's my fault though, where I moved the actuator I used my own bolts and washers, would appear the washers weren't strong enough to hold it together.
The good new though is it hit 20psi before 2krpm and pulled like a train! Only set it to 25 or so psi peak but two power runs and bye bye turbo
Think it's my fault though, where I moved the actuator I used my own bolts and washers, would appear the washers weren't strong enough to hold it together.
The good new though is it hit 20psi before 2krpm and pulled like a train! Only set it to 25 or so psi peak but two power runs and bye bye turbo