21-06-2014, 02:29 PM
Today consisted of shredding my hands fitting the clutch cable, got it in the end though. Then turned my attention to the heater matrix pipes, one of the pipes connects down near the turbo actuator, so i bastardized the metal pipe off my gti-6 engine and to be fair it looks like it rolled out the factory like it. The other pipe was simpler to make, again using a bend and a piece of metal piping from the 1.8 engine and it was done.
Next i turned my attention to the fuel lines, again bastardized a bracket off the 6 engine and shortening the existing fuel pipes from the turbo engine its all sitting pretty good.
I know this engine looks untidy so part of my build is to try and make it tidier.
[attachment=17005]
[attachment=17006]
[attachment=17007]
[attachment=17008]
Next i turned my attention to the fuel lines, again bastardized a bracket off the 6 engine and shortening the existing fuel pipes from the turbo engine its all sitting pretty good.
I know this engine looks untidy so part of my build is to try and make it tidier.
[attachment=17005]
[attachment=17006]
[attachment=17007]
[attachment=17008]
1999 2.0 8v Turbo 306
Flying the Flag for the XU10J2TE
You Tube: 832 Performance
Flying the Flag for the XU10J2TE
You Tube: 832 Performance