Seats coming forward for mot

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Seats coming forward for mot
#1
Do both seats need to come forward to let people in and out of the back seats?
Or shall I just remove the back seats for the mot?
[Image: signiture.jpg]
Midnightclub Wrote:All the cool kids have ph 2 Nile 6's!
Reply
Thanks given by:
#2
Would imagine they do as its there only exit, but may be wrong, just rip them out anyway, who needs rear seats :p
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |

[Image: sigi-2.png]
Reply
Thanks given by:
#3
I'd imagine so... if in doubt just remove it, it's such a quick job
Reply
Thanks given by:
#4
exactly my thoughts, three bolts and they're gone, may aswell go whip them out now, and see if I have a resisitor to fool the lack of passenger air bag while I'm at it. ..
[Image: signiture.jpg]
Midnightclub Wrote:All the cool kids have ph 2 Nile 6's!
Reply
Thanks given by:
#5
Remove the seat belts too. I spoke to my mechanic when I had only partially stripped the Rallye and he said it would fail if the seatbelts were in.

Again on a two min job Smile
[Image: 20A1806D-891D-40FB-BD52-AD519177A607-734...391753.jpg]
TEAM CONROD SHITTING RALLYE!
Reply
Thanks given by:
#6
Anyone know what spec resistor i need to stop the airbag light if i'm removing them...?
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
#7
1.2 I think.
[Image: 20A1806D-891D-40FB-BD52-AD519177A607-734...391753.jpg]
TEAM CONROD SHITTING RALLYE!
Reply
Thanks given by:
#8
Well I couldn't be f*cked I think it had been like that for a few years and never got any advisories. And my next question was what resistor would I need, so cheers matt.

You talking about actually removing the airbag from passenger side yeah?
[Image: signiture.jpg]
Midnightclub Wrote:All the cool kids have ph 2 Nile 6's!
Reply
Thanks given by:
#9
Found it eventually, 3 ohms apparently. This is according to stevieg, can't find any other reference to it.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
#10
(31-10-2012, 09:14 AM)Poodle Wrote: Found it eventually, 3 ohms apparently. This is according to stevieg, can't find any other reference to it.

nice one cheers mate, pretty sure its still not an mot failure yet so I should be ok today
[Image: signiture.jpg]
Midnightclub Wrote:All the cool kids have ph 2 Nile 6's!
Reply
Thanks given by:
#11
Yeah it's not a failure yet, so wouldn't worry Smile
Reply
Thanks given by:


Forum Jump:


Users browsing this thread: 4 Guest(s)