Cyclones with 15mm spacers?

[Oil-burner]

I've bought some 15mm spacers and stud conversions for my aidels but don't have tyres for them yet.
I'm doing my disks and pads today and thought I may aswell chuck the spacers and conversions on while I'm at it, but that will mean I'm running at ET4, will I have any scrubbing/clearance issues?
Cheers

Also has anyone got pics of cyclones with spacers?

[Pompey306mark]

Doubt it. I run my borbets which and 16's and wider than cyclones at et0.

I did have to roll the rears, but you should get away with it on cyclones.

---

If you want pics, in my project thread I think my orange cyclones were running at et9 or something.

[Oil-burner]

I know I'll get away with the rears cos they are really sat into the arch anyway, it's the fronts I'm wondering about tbh, I'm down -40mm and running 195/55's you still think ill be ok? Don't want to risk ruining the arches for the sake of a 15min job.

[Pompey306mark]

I don't think you will have a problem. As said I am running bigger and et0.

[Oil-burner]

Sound, I'll let you know how I get on!

[Scott]

Should be fine. People run 15mm spacers (or 13mm if they buy custom ones) for the Wilwood 4-pot conversion without issues

[ChezHdi]

get a pic up with the cyclones on with the spacers! im looking to get some if it makes the back look phat and you have no issues be ideal ;D

[Pompey306mark]

Rear with spacer.

Front with spacer.

[ChezHdi]

I like it, You have any issues with them?? scrubbing or out??

[Pompey306mark]

Had no issues. I know some pull the arches a bit.

[Oil-burner]

Nice, I'm only putting them on to save time for when I get some rubber on the aidels.
I will post pics when they're on!