24-09-2020, 12:21 AM
(This post was last modified: 24-09-2020, 12:44 AM by darrencurry0808.)
N75 valve and boost sensor mounted for the Digibooster...
Couldn’t find any inlet / compressor elbows that suited so went ahead and made up my own to suit the new routing of the intercooler piping [emoji3526]
Air filter fitting in nicely, sitting right above my cold air feed.. pay not attention to the mock up exhaust piece as the bay was getting it tight with soot [emoji1787][emoji1787]
Standard shocks back in ( for now ), new lower arms, drop-links, ball joints and hub carriers painted [emoji736]
Sent from my iPhone using Tapatalk
Slam panel painted and ready for bolting on.. this will now allow me to get the intercooler and oil cooler secured now so will be glad to get that job out of the way also!
Slam panel fitted and both coolers mounted up [emoji1305] starting to come together now! Also intercool piping finished, used 2.5” piping from the turbo and 2.75” going into the inlet.
Sent from my iPhone using Tapatalk
Drill and grooved disks with brembo pads, should make a little difference in the stopping power hopefully [emoji1694][emoji1694]
Managed to get the front callipers re done!
Rears needing done soon, along with making up some new lines to run to the rear also and the brakes should be back!
Sent from my iPhone using Tapatalk
Started to put together my custom 2.5” full stainless steel straight through. Starting with the down pipe.
Forgot to take pics during the making of the down pipe [emoji1748]
Anyways... here it is finished and heat wrapped ready for fitting!
Sent from my iPhone using Tapatalk
Couldn’t find any inlet / compressor elbows that suited so went ahead and made up my own to suit the new routing of the intercooler piping [emoji3526]
Air filter fitting in nicely, sitting right above my cold air feed.. pay not attention to the mock up exhaust piece as the bay was getting it tight with soot [emoji1787][emoji1787]
Standard shocks back in ( for now ), new lower arms, drop-links, ball joints and hub carriers painted [emoji736]
Sent from my iPhone using Tapatalk
Slam panel painted and ready for bolting on.. this will now allow me to get the intercooler and oil cooler secured now so will be glad to get that job out of the way also!
Slam panel fitted and both coolers mounted up [emoji1305] starting to come together now! Also intercool piping finished, used 2.5” piping from the turbo and 2.75” going into the inlet.
Sent from my iPhone using Tapatalk
Drill and grooved disks with brembo pads, should make a little difference in the stopping power hopefully [emoji1694][emoji1694]
Managed to get the front callipers re done!
Rears needing done soon, along with making up some new lines to run to the rear also and the brakes should be back!
Sent from my iPhone using Tapatalk
Started to put together my custom 2.5” full stainless steel straight through. Starting with the down pipe.
Forgot to take pics during the making of the down pipe [emoji1748]
Anyways... here it is finished and heat wrapped ready for fitting!
Sent from my iPhone using Tapatalk