20-04-2020, 10:52 PM
(This post was last modified: 20-04-2020, 11:15 PM by darrencurry0808.)
Todays work consisted of sorting a cold air feed, straight into the air filter’s location.
Cut out the triangular support piece as it was battered and bent all roads.
Used my plasma cutter to cut the hole for the pipework, used some 2” exhaust tubing I had laying around and came up with this. [emoji3596][emoji3596]
Ive left it a little bit longer so I can work with it until I know where Im going to run the feed from, I was considering using the fog light hole as an air supply, although Im not sure if Im going to be fitting the fogs or using the covers..
Cut and welded in replacement support piece, excuse the welds lol... not fully onto it yet [emoji1787]
Sent from my iPhone using Tapatalk
Thanks mate [emoji1305]
Sent from my iPhone using Tapatalk
Cut out the triangular support piece as it was battered and bent all roads.
Used my plasma cutter to cut the hole for the pipework, used some 2” exhaust tubing I had laying around and came up with this. [emoji3596][emoji3596]
Ive left it a little bit longer so I can work with it until I know where Im going to run the feed from, I was considering using the fog light hole as an air supply, although Im not sure if Im going to be fitting the fogs or using the covers..
Cut and welded in replacement support piece, excuse the welds lol... not fully onto it yet [emoji1787]
Sent from my iPhone using Tapatalk
(18-04-2020, 08:56 PM)Dturboleeds Wrote: Good work
Sent from my iPhone using Tapatalk
Thanks mate [emoji1305]
Sent from my iPhone using Tapatalk