Cully's Bianca 6 R150 YVM

[cully]

well i didn't get the six! tell me i made a wise move!?

story time!

these are the pictures that sold the car to me in the first place

   
   

so after lots of messaging i got the price down from 1300 to 750 less than a month MOT left and 6 month tax
subject to viewing,
so today was the day i went with £1000 in hand to go view on the hope of driving away

first inspection found
4x new kumo 195x45x16 on speedlines nice!!!!
condensation in masked headlight
C/L worked on drivers door only
no radio
service light on
paintwork Highly polished but left to go dull
lifted bonnet water low in rad
ign on fans ran fullspeed from warm ign off fans ran at half speed
topped up water this stopped
engine quiet no tapping through rev range on idle
idle control sticking

Test drive
Clutch slipping
engine pulls strong in all gears
gears smooth
reverse stick release sticking open letting gate to reverse
clonk from back on revers locks
clonk from front on forward take after reverse only
water leaking out poor sealing rad cap no bubbles in water has antifreeze

Jacked up car from centre of rear beam
No CAT
N/S handbrake cable broken
O/S Beam f*cked! i mean really f*cked in out movement and up down
arch liner all eaten away


bodywork very clean
interea very clean

sum up
this car in its life has been a show car highly polished and clean to such an extent some of the body edges have been polished through to the primer

i believe this car in the last two owners has been neglected and as it stands needs a major overhaul
things needed
Cambelt
clutch
rear beam
handbrake cable
probably service


this will be a nice car again if someone is prepared to spend a load of money