07-05-2012, 06:14 PM
yep two male spade connectors, two female ones, there are the two wires coming from the probe, shown in a circuit diagram on that page i linked you. chop them, then add a bit more wire if needs be, then id personally stagger them to reduce the chances of them touching, then crimp on some spade connectors and cover.
as for the probe, i think Chris meant to drill a hole in the plastic outlet of the ic itself, then araldite the probe in there, then that should tell what temp the air is thats actually going to engine, and you'll be able to see what the difference is when you start spraying
as for the probe, i think Chris meant to drill a hole in the plastic outlet of the ic itself, then araldite the probe in there, then that should tell what temp the air is thats actually going to engine, and you'll be able to see what the difference is when you start spraying
Member of the 99% warning or you're nothing club