Bens bosch conversion dont use the wrong key!

[Ben Jay]

ive not got round to fitting it yet! going to pop to halfords and pick up some more washer bits and bobs as i dont htink the tube i have is a good diameter.

if you're talking about the boost gauge - the pipe tends to have a smaller diameter than the gauge and T-piece, you need to warm it in boiling water/lighter and stretch it over - a pipe too big will just pop off mate.

If you bought it as a pack, pipe included, it will be the right one.

so the pipe from the back of the gauge to the t peice is fine. its just getting a reducer that goes in the boost compensator pipe