Sam's 2.0 16v VNT ph1 rep HDi

[Sambarker]

Few little jobs done:

Made some stainless studs for the exhaust manifold which at the moment is just a laser cut 12mm mild steel plate awaiting some pipe work!



Had to make a minor adjustment to the 8v pump bracket in order to clear the 16v head





And sorted out a top engine mount bracket which will a) fit the 8v bottom end b) fit the 16v head and c) clear the fuel pump bracket!





Crank seal also fitted and ready for clutch and gearbox is next jobs! And fitting of the arp studs and fitting timing belt, refitting ancillaries and getting ready to drop into car!

Thanks for reading



Sent from my iPhone using Tapatalk