27-12-2016, 01:46 AM
Found a bit of time to be vaguely creative. Hopefully this will be a decent solution... ive made a cup holder for the 306. It replaces the tub that goes in the back of the lower centre console. Its designed to fit moderate sized cups and has ridges in the bottom to hold anything smaller. In order to hold anything ive made the holding part as wide as possible which will require the console to be slightly trimmed.
And last time I got my LED Shift light holder printed it came out the wrong size. Looks like it was my mistake with scaling in the software so ive scaled it up and angled it as Im going to mount it upsidedown probably from the top of the speedo.
All due to arrive in the first week of january so hopefully it will all fit when it arrives and I wont have blown a whole load more money on useless prints.
And last time I got my LED Shift light holder printed it came out the wrong size. Looks like it was my mistake with scaling in the software so ive scaled it up and angled it as Im going to mount it upsidedown probably from the top of the speedo.
All due to arrive in the first week of january so hopefully it will all fit when it arrives and I wont have blown a whole load more money on useless prints.