Right.. random question, as i wanna rebuild the seals etc while im in this area do these look right?![[Image: 8d122016fa266fc32d2d7fd408ccadb8.jpg]](http://uploads.tapatalk-cdn.com/20160705/8d122016fa266fc32d2d7fd408ccadb8.jpg)
![[Image: d5e5ca88b2aa3798b4e1c84b9158da2e.jpg]](http://uploads.tapatalk-cdn.com/20160705/d5e5ca88b2aa3798b4e1c84b9158da2e.jpg)
![[Image: 79ccf5982f0550b54770beef2c2b0abc.jpg]](http://uploads.tapatalk-cdn.com/20160705/79ccf5982f0550b54770beef2c2b0abc.jpg)
Also ordering fork bushes because in a word there f*cked.![[Image: 01c44bb722a2689a9d78fd7ee1949f28.jpg]](http://uploads.tapatalk-cdn.com/20160705/01c44bb722a2689a9d78fd7ee1949f28.jpg)
Sent from my SM-G920F using Tapatalk
Also replacing the bolts for the pressure plate, they were abit naff the last time i fitted them and this time i had to undo to of them by smacking them with a screwdriver. Got shit loads of bolts at work and was wondering if stainless capheads would be ok? And are washers required or run without like the oem setup?
Sent from my SM-G920F using Tapatalk
Also ordering fork bushes because in a word there f*cked.
Sent from my SM-G920F using Tapatalk
Also replacing the bolts for the pressure plate, they were abit naff the last time i fitted them and this time i had to undo to of them by smacking them with a screwdriver. Got shit loads of bolts at work and was wondering if stainless capheads would be ok? And are washers required or run without like the oem setup?
Sent from my SM-G920F using Tapatalk
Justin_306DTurbo
306 Ph1 Dturbo Sedan
306 Ph1 Dturbo Estate (VNT)
Partner Ph1 (XUD Swap)
306 HDI Stage 3 Estate (RIP)
306 Ph1 Dturbo Sedan
306 Ph1 Dturbo Estate (VNT)
Partner Ph1 (XUD Swap)
306 HDI Stage 3 Estate (RIP)
