Dr_Jekyll & Mr_Hyde Estate Project

[dr_jekyll]

Right so done a couple of bits now since expo, now got full working heaters thanks to aggy again!
Ended up being a small peugeot meet at his house


His xud 205 im still jealous off! Must make my own one day in a gti shell [GRINNING FACE WITH SMILING EYES]

After searching for seats for a while bit the bullet and bought piggys seats aswell. Turned out some bright spark had welded a bracket to the subframes for the seat belt pre-tensioners which has saved me heaps of work!

Also modded up some gti6 rear seats to fit, genuinley cannot believe how easy it is to do. Did start by pulling a meridian seat to pieces fully removing the cover from the sponge.

Then when i came to remove the gti seat it dawned on me they do actually come away with the sponge so what i though was a 30min job ended up being 5mins.
As everyone knows the latches are different.

But the hole still lines up without cutting and the plastic trim can be fitted and screwed through the material.
Once in the hole isnt visble either.

The only gash thing is that theres a hole left from the button so i think its best to push and glue it in to plug the hole neatly.
All in all gti bench is a nice touch with the bucket seats and suede roof lining.

Next is to suede the door cards and center console again