DW10 Bolt Torque specs

[Frosty]

All of what you have listed i would usually do up tight by feel but here is hopefully all you'll need from auto data

Cylinder head instructions : Autodata NoteIllustration
Cylinder head
Maximum bolt length: 133,4 mm
Tighten: 20 Nm
Tighten: 60 Nm
Tighten: 110°
Tighten: 110°
Other engine tightening torques
Main bearings Renew bolts/nuts: No
Main bearings Stage 1: 25 Nm
Main bearings Stage 2: 60°
Big end bearings Renew bolts/nuts: Yes
Big end bearings Stage 1: 20 Nm
Big end bearings Stage 2: 70°
Oil pump to cylinder block : 16 Nm
Sump bolts : 16 Nm
Sump drain bolt : 34 Nm
Flywheel/driveplate : 48 Nm Autodata Note
Clutch pressure plate : 20 Nm
Crankshaft pulley/damper centre bolt : 70 Nm+62° Autodata Note
Camshaft sprocket/gear : Autodata Note
Camshaft carrier/cap : 10 Nm
Camshaft/rocker cover : 10 Nm
Inlet manifold to cylinder head : 23 Nm
Exhaust manifold to cylinder head : 30 Nm
Injector/clamp : 30 Nm
Injector pipe unions : 20 Nm
Fuel/injection pump sprocket/gear : 50 Nm
Fuel/injection pump flange : 20 Nm
Fuel/injection pump mounting : 23 Nm
Glow plugs : 10 Nm
Engine coolant temperature (ECT) sensor : 17 Nm
Engine oil pressure switch : 30 Nm
Chassis tightening torques
Front hub : 325 Nm
Rear hub : 185 Nm Autodata Note
Steering track rod end : 35 Nm
Brake caliper to carrier Front: 30 Nm
Brake caliper/carrier to hub Front: 110 Nm
Brake caliper/carrier to hub Rear: 120 Nm
Back plate to hub Rear: 40 Nm
ABS sensor Front: 10 Nm
ABS sensor Rear: 10 Nm
Road wheels : 100 Nm Autodata Note