So got the bremsport today,quite concerned about the box they came in as one end was completely open but luckily I don't think there anything missing.
I didn't have the right socket (18mm I think) to take the caliper off so just got wood off cuts to mock up a base to lay the calipers over the cyclone.
So they look like they should clear obviously the 280mm disc brings the caliper closer to the centre of the wheel which is a littLe bit scary also I noticed I could probably sand the ends of the pads to get even my clearance.I'm hoping to get down to my mates garage 1 Friday and check for definite if they clear.Also Found the product code on the pads so ill order a new set.
[attachment=19738]
[attachment=19737]
[attachment=19736]
[attachment=19735]
Quick question :on the standard disc's They are 2 screws.On the 280mm dics the isn't any holes ?
I didn't have the right socket (18mm I think) to take the caliper off so just got wood off cuts to mock up a base to lay the calipers over the cyclone.
So they look like they should clear obviously the 280mm disc brings the caliper closer to the centre of the wheel which is a littLe bit scary also I noticed I could probably sand the ends of the pads to get even my clearance.I'm hoping to get down to my mates garage 1 Friday and check for definite if they clear.Also Found the product code on the pads so ill order a new set.
[attachment=19738]
[attachment=19737]
[attachment=19736]
[attachment=19735]
Quick question :on the standard disc's They are 2 screws.On the 280mm dics the isn't any holes ?
![[Image: Cn91r40h.jpg]](http://i.imgur.com/Cn91r40h.jpg)
Astor 6 Fast road/track project
