22-10-2014, 04:00 PM
Bolts have Arrived! These are the longer ones which are long enough to run the baker BM mounts with a strut brace.
For the record these are the wires for the two sockets found on the passenger side chassis leg. These are needed for any loom conversion etc.
19 pin GTI-6 connector
140 obd socket (green) - Not Used
141 obd socket (beige) - Not Used
480 engine fault light (beige)- Not Used
401 coolant temp gauge (beige)
M444 permanent earth (yellow/green)
414 oil level gauge (yellow)
415 oil level gauge (green)
410 oil pressure warning light (yellow)
465 vehicle speed sensor (yellow)
426 rev/tacho speed (red)
411 oil temp sender (red) - Not Used
CC4 airbag control switched live (grey)
C120 Reverse light switch (grey)
220 Reverse light switch (orange)
123 lambda switched live (grey) - Not Used
1070 Alternator warning light (dark brown/red)
400 Coolant temp gauge (white)
100 Starter motor switched live (thick white)
120 fuel pump switched live (thick white)
8 Pin GTI-6 connector - Not used cut off and seal off bare ends of wiring.
For the record these are the wires for the two sockets found on the passenger side chassis leg. These are needed for any loom conversion etc.
19 pin GTI-6 connector
140 obd socket (green) - Not Used
141 obd socket (beige) - Not Used
480 engine fault light (beige)- Not Used
401 coolant temp gauge (beige)
M444 permanent earth (yellow/green)
414 oil level gauge (yellow)
415 oil level gauge (green)
410 oil pressure warning light (yellow)
465 vehicle speed sensor (yellow)
426 rev/tacho speed (red)
411 oil temp sender (red) - Not Used
CC4 airbag control switched live (grey)
C120 Reverse light switch (grey)
220 Reverse light switch (orange)
123 lambda switched live (grey) - Not Used
1070 Alternator warning light (dark brown/red)
400 Coolant temp gauge (white)
100 Starter motor switched live (thick white)
120 fuel pump switched live (thick white)
8 Pin GTI-6 connector - Not used cut off and seal off bare ends of wiring.