07-04-2014, 05:46 PM
(07-04-2014, 12:08 PM)Grant Wrote: Nice work Sam.
How did you get the reverse cable into the brake lever?
So.... it took forever. First I cut off the plastic collar off the cable. Then I took a dremel to the cables outer and cut that back about 2 inches. This was far too much so I had to put a few nuts in to make up the gap.
The brass clamp on the end of the wire was too big for the lever so I had to sand off about 3mm. The diameter of the gear stick is a lot smaller than the hole on the lever. To fix this I went round and round the stick with electrical tape to pack it out. And yeh... thats how I did it. Its not perfect but it works! Just!
(07-04-2014, 12:47 PM)7057sam Wrote: Good laugh sunday
Yeah really impressed how the 1.8 handles definitely makes up for the lack of power it may have though I its the quickest 1.8 I've been in and much quicker than my old xsi.
Yeah searching as we speak for a weekend trackday,think we could have some interesting battles in the bends
Yeh the first bend! Then after that youll be miles away. Itll all be better once its mapped.