Hunter the B-road sigma..

[ginge191]

So thought id start this off just to post updates and more likely questions i have about XUD's in general rather than spamming up the site!

From my old 1.4 Sigma to an identicle, XTDT!

So to begin, i got myself another Sigma, this time an XTDT, and i think when i drove it, it hadn't been touched in a LONG time... There were a fair few webs on it, pedals were VERY stiff but after giving it a drive around for a bit, everything come into place quite nicely.

The bodywork etc. is immaculate apart from the drivers side front quarter panel for which i have a replacement from the old pug, get that on soon!

Interior, erm.. well wood effect dash?? whats with that?? fugly as hell, got my old interior ready to put in, thinking i'll matte black it fist.
Electrics all round which all work fine....


anyway, less chat more pics!

Old:


New:





Fairly clean engine bay, checked the turbo and its running a KKK, wanting to change this..


Rocker Cover Gasket needed?



Also Air filter needs replacing - i think!?



Plans are simple
-Coilovers
-Bosch
-FMIC
-T2 Turbo

cheers

My plans for this are to create an island road car, for 'dicking' cars in the corner, some nice low end boost, maxing out at around 80mph, and no im not endorsing speeding, but large turbos and POOWAAAH is not what this project is about

Just to update where i've got with this 'project' if you like to call it that

I've purchased:

- Coilovers
- Bosch pump
- T2 turbo
- rear beam mounts
- MBC
- boost gauge

So today i managed to change my front quarter panels over

Top panel (before)



also found this plug - any ideas, it was tucked next to my screen wash tank?? im assuming its a sensor for washer tank levels maybe???

Also managed to pipe in my boost gauge, managed to figure out which wires go where but never got round to wiring it - gauge reads a steady 13psi - not too bad, i was expecting a leak somewhere but helps a lot having that in!
pics of this once its all installed with a mount...

plans for next couple weeks to have the whole car lowered on coilovers and