14-10-2013, 04:55 PM
Right ive found loads of photos from updates i never made!
Bucket seats when they first went in. Look the same now but they are bolted in properly. H frames ontop of the standard sliders arent actually too high and are low enough!
I smoothed the estate key trim. Looked perfect but over time the key hole is starting to show again. Will need to sand it down again and respray!
and lowering. Kept this one as a bit of a secret before pugfest. Anyway that was done at KrisBs. It took about 5 hours to do. We started at 8pm and finished at 1am!
I wanted to fit aftermarket rear speakers and wanted them quick so got some from halfords. 5x7 so should fit...
obviously not!
so some angle grinding happened!
and then they were in!
At the same time I added lots of silentcoat to the boot lid and put all of the cables on the inside of the boot lid instead of cable tied to the outside. Also Dewipered but I dont have any pictures of that!
End of ancient update!
Bucket seats when they first went in. Look the same now but they are bolted in properly. H frames ontop of the standard sliders arent actually too high and are low enough!
I smoothed the estate key trim. Looked perfect but over time the key hole is starting to show again. Will need to sand it down again and respray!
and lowering. Kept this one as a bit of a secret before pugfest. Anyway that was done at KrisBs. It took about 5 hours to do. We started at 8pm and finished at 1am!
I wanted to fit aftermarket rear speakers and wanted them quick so got some from halfords. 5x7 so should fit...
obviously not!
so some angle grinding happened!
and then they were in!
At the same time I added lots of silentcoat to the boot lid and put all of the cables on the inside of the boot lid instead of cable tied to the outside. Also Dewipered but I dont have any pictures of that!
End of ancient update!