Frosty's Ph1 Black D Turbo now with VNT

[Frosty]

Time for an update, I got a bit more done to the car tonight after work. I have made a start putting the inside back together. Pretty much all the dash bits are back where they should be just need to sort out the rear seats and a good clean. I have got the stereo all fitted into the lower centre console. I have got a slight earth problem though. When I put the car into reverse the gauges flicker which I think it down to a bad earth. I have cleaned up some of the earth points but it made no difference so if anyone has any ideas that would be great

I have been having a look at my intake set up and it is so tight where it goes between the servo and inlet manifold. Its pretty much touching a metal brake pipe and 1 of the heater matrix hoses so im not overly happy about that so I need to come up with something to do or poss get smaller pipe which I don't really want to do as the stuff aint cheap. Also I have rolled (hit with a hammer) the rear arches which is ready for when I fit the challengers with the 20mm spacers. As for some of the body work I have decided just to get the minimum done at the moment. I have got the front bumper, side trim, grill and hockey sticks all being done. I wanted to get more done but im running out of time and at the end of the day its an old 306 so its never going to be perfect.

So the plan is to have this on the road 1st September which at this moment in time shouldn't be a problem, though im not sure what state it will be in. I think I have sorted out the insurance so I just need to get that paid for next week and get it taxed and it should be on the road

Will upload some pics tomorrow hopefully