27-07-2013, 07:11 PM
(This post was last modified: 27-07-2013, 07:12 PM by PugLover1984.)
Yeah it's primed properly and the filter housing is full. I've done a load of troubleshooting too.
Took the top hoses off the housing. Fuel is coming out of the the thicker pipe as it should. As said previously I have tried the old filter. No joy.
Took off the bottom hose on the right hand side, fuel escaped so no blockage in the bottom of the housing.
Any ideas?
I've also tried the bleeding procedure as per the Haynes manual.
Took the top hoses off the housing. Fuel is coming out of the the thicker pipe as it should. As said previously I have tried the old filter. No joy.
Took off the bottom hose on the right hand side, fuel escaped so no blockage in the bottom of the housing.
Any ideas?
I've also tried the bleeding procedure as per the Haynes manual.