Nadine + Sarah's project '6

[Nadine]

Well managed to do a fair few bits since the last update. And a few bits that I wanted to wait for but needs must made me have to do it.
So I took the car for a wee health check to make sure she was ok and not holding any nasty surprises. So underneath she is pretty solid, found she needed a drop link, 2 p bushes and a rear brake flexi. Also an airbox as it was missing. So arranged for all that to bed done
Then we had a look at the rear brakes and em well I'm pretty sure this isn't meant to happen

Bit the bullet and arranged for a refurb beam to be fitted with a new calliper and rear brake discs and pads.
Also discovered one of my cyclones are buckled so looking to get a new set of wheels, fancy a set of speedlines
At the health check we also figured out she needs a new coolant sensor and lambda sensor.
I replaced the fan sensor as well as the coolant sensor, but pretty sure it's down to the bitron unit, the unit has corroded that much that pins have snapped off inside the plug. So I need a new plug
I fitted my new ariel so no more leak from there, however drivers door doesn't close properly at the top so letting water in, need new hinges.
Fitted my crystals
Fitted my new bumper
Fitted colour coded bump strips, this is how she sat do now


Comments welcome

---

Oh the rear beam was also lowered 40mm before fitting so just need front springs now