Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
De-glazing cylinders
#3
You want to use something like 3in1 for a lube. Fairly light pressure and keep at it on probably about 1/4 drill speed. You want the hatching to be slightly less than a 45 degree angle tk each other until the bores are almost a Matt finish. Don't be scared to put too much pressure on but just remember to keep it regularly lubed up....giggidy
Team Eaton


1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft
Reply
Thanks given by:


Messages In This Thread
De-glazing cylinders - by Ben - 03-10-2012, 05:55 PM
RE: De-glazing cylinders - by CJ_Derv - 04-10-2012, 07:03 AM
RE: De-glazing cylinders - by Niall - 04-10-2012, 07:21 AM
RE: De-glazing cylinders - by Ben - 04-10-2012, 03:41 PM
RE: De-glazing cylinders - by Niall - 04-10-2012, 03:49 PM
RE: De-glazing cylinders - by Dave - 04-10-2012, 03:53 PM
RE: De-glazing cylinders - by samass - 04-10-2012, 03:54 PM
RE: De-glazing cylinders - by CJ_Derv - 05-10-2012, 07:55 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  possible faulty injector, running on 3 cylinders rickye 11 3,049 13-02-2013, 10:09 PM
Last Post: rickye

Forum Jump:


Users browsing this thread: 1 Guest(s)