MG ZR: Cams & Maps

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MG ZR: Cams & Maps
Awesome Steve!!!!

Did you leave the cap off after your road trip to hopefully let out the last of the trapped air as the K-series seems to trap air and It comes back in the form of HG Sad

Has procta got any milk bottle tops you can use as discs Wink
[Image: siggy1.jpg]

the smokey old bus that sounds like a tractor...
Reply
Thanks given by:
(09-07-2014, 08:45 PM)devils_fuel Wrote: Awesome Steve!!!!

Did you leave the cap off after your road trip to hopefully let out the last of the trapped air as the K-series seems to trap air and It comes back in the form of HG Sad

Has procta got any milk bottle tops you can use as discs Wink

I didn't no :/ I did bleed the system until water came out the bleed point then had the engine on with blowers on hot for a while then let it all cool down with the cap off before taking it on the road. Should be fine right?

Milk bottle tops? If that's a joke about brake size I'll let you know I've got the same size as 6' brakes but on a lighter car Tongue
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
If I was you Steve I'd go for a 20 min gentle drive tonight and then take the rad cap off when back home, check the level and then leave it off for the night so the last bit of air hopefully goes. PS remember to put the cap back on tomorrow morning lol

Yeah it's a joke, are they as thin as bottle tops?
[Image: siggy1.jpg]

the smokey old bus that sounds like a tractor...
Reply
Thanks given by:
I'll have a look tomorrow morning see if the coolant level has gone down, bit late now to be out messing with it

(09-07-2014, 08:04 PM)procta Wrote: great!! just a shame a bout the shell been so heavy.
Well you only have a 143 engine, so you're already loosing Tongue
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
(09-07-2014, 09:24 PM)lolsteve Wrote: I'll have a look tomorrow morning see if the coolant level has gone down, bit late now to be out messing with it

(09-07-2014, 08:04 PM)procta Wrote: great!! just a shame a bout the shell been so heavy.
Well you only have a 143 engine, so you're already loosing Tongue

what makes you say I have a 143 engine? Tongue I have a 160 engine, with the early ecu, so that I can run the de cat. As the later ecu setup isn't that keen on de cats. my car is running a hybrid setup you might aswell say.
Reply
Thanks given by:
Glad it's all back together and running mate

Metros are obviously lighter they have had more chance to rot lol
[Image: image_zps45f2003b.jpg]

Team Doesn't own a 306
Reply
Thanks given by:
(09-07-2014, 09:49 PM)Danny2009 Wrote: Glad it's all back together and running mate

Metros are obviously lighter they have had more chance to rot lol

that's true dan,
Reply
Thanks given by:
Well done getting this sorted. Maybe you won't hold me up on track in the future?
Reply
Thanks given by:
(09-07-2014, 08:45 PM)devils_fuel Wrote: Awesome Steve!!!!

Did you leave the cap off after your road trip to hopefully let out the last of the trapped air as the K-series seems to trap air and It comes back in the form of HG Sad

Has procta got any milk bottle tops you can use as discs Wink

these are to big and to heavy to run metro brakes sadly. remember this posh rover isn't a match box / pocket rocket. its just a heavy posh rover.
Reply
Thanks given by:
Well done mate, glad to hear she's working. Reckon you've got your lost ponies back?
Reply
Thanks given by:
Nice one, glad to hear it. How come no victory visit?? :p
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
Well done mate...

I wouldnt run it without rad cap for too long...as long as you've blead it well and have decent heaters and no cold spots, it be fine. These bleed up nicely Smile
Wishes for more power...
Reply
Thanks given by:
I've never understood the whole "leave the rad cap off" thing, what do you think the expansion tanks for..?
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
Cheers Danny, fingers crossed it stays running for a while

(09-07-2014, 09:49 PM)procta Wrote: what makes you say I have a 143 engine? Tongue I have a 160 engine, with the early ecu, so that I can run the de cat. As the later ecu setup isn't that keen on de cats. my car is running a hybrid setup you might aswell say.
Blast, thought I had one up on you then. will just have to get a remap then Smile

(09-07-2014, 09:56 PM)SRowell Wrote: Well done getting this sorted. Maybe you won't hold me up on track in the future?
Don't be butthurt that a throttle bodied 1.8 couldn't keep up with a rover with headgasket failure and budget tyres Tongue

(10-07-2014, 03:50 AM)Dum-Dum Wrote: Well done mate, glad to hear she's working. Reckon you've got your lost ponies back?
Not sure yet, haven't really given the engine a thrashing yet just to let everything bed in etc. If this doesn't fix it though I'm out of ideas where the ponies have gone

(10-07-2014, 05:37 AM)Poodle Wrote: Nice one, glad to hear it. How come no victory visit?? :p
Sorry dude, was tempted but wanted to stay somewhat close to home in case the worst happened. So I took part in a long chav tradition of a pilgrimage to MacyDs Tongue
(10-07-2014, 06:48 AM)Piggy Wrote: Well done mate...

I wouldnt run it without rad cap for too long...as long as you've bled it well and have decent heaters and no cold spots, it be fine. These bleed up nicely Smile
Thanks man, feels good to try something more ambitious for a change rather than chickening out and going the steel seal route.
Heaters are warm and the bleed screw was letting water out so assume it's well bled bu
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
(10-07-2014, 11:04 AM)Poodle Wrote: I've never understood the whole "leave the rad cap off" thing, what do you think the expansion tanks for..?

Exactly your not doing anything extra by leaving it off. Only possibly forgetting to put it back on and then driving it the next morning and loosing all of your coolant!
Team Eaton


1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft
Reply
Thanks given by:
i have only left the cap off to let the car burp, and that's on tick over. As metros are not the easiest of cars to bleed,
don't give it any shit just yet, look into the waterless coolant too, as i am going to run that shortly, rather than the pink stuff.
Reply
Thanks given by:
(09-07-2014, 09:56 PM)SRowell Wrote: Well done getting this sorted. Maybe you won't hold me up on track in the future?
Don't be butthurt that a throttle bodied 1.8 couldn't keep up with a rover with headgasket failure and budget tyres Tongue
[/quote]

You were holding me back bro! I was all over you in the corners!
Reply
Thanks given by:
Went for a small drive to forest today to take puppy out for a walk and left cap off while out just in case it helps, don't want to give it any excuses.

I'm slowly bedding it in by keeping off the vvc for now. just gave it one heavy foot go to make sure oil was getting up into the HCU.

Budget tyres/no oil bro! Wait for me to get some decent 16s and we will see! Tongue

Also got back a checksum'd file for my edited map from a gent on a ecu tuning forum. I modified what I thought was the rev limit but now not sure as the guy found a few other cases of 7200 being mentioned
"I'm not sure if that is the right limiter or not, as I found 7200 in two other places.
So I did another file with that changed to 7450
zrlimiter-phil-chk-ok

Both of em are in that rar file anyway."
[Image: mcetg0.png]

ZR VVC Homebrew mapping project: http://306oc.co.uk/forum/showthread.php?tid=14360
Reply
Thanks given by:
(10-07-2014, 07:44 PM)SRowell Wrote:
(09-07-2014, 09:56 PM)SRowell Wrote: Well done getting this sorted. Maybe you won't hold me up on track in the future?
Don't be butthurt that a throttle bodied 1.8 couldn't keep up with a rover with headgasket failure and budget tyres Tongue

You were holding me back bro! I was all over you in the corners!
[/quote]


I wouldn't worry Srowell, these posh rovers were eaten by two metro cup cars that were class c spec, and they were only 1.4 16vs, they had a split race.
Reply
Thanks given by:
(08-07-2014, 11:11 PM)toseland Wrote: Still want the ZT-T V8 tho...

Dribble...

The closest I've got has been a Trophy Blue ZT-T CDTi 136 so far. Would need to be a lottery win before I could afford to run a V8 !
Reply
Thanks given by:
Im sorry.......

But....are people REALLY dribbling over a ZT-T v8???!!

Undecided
Wishes for more power...
Reply
Thanks given by:
(10-07-2014, 10:15 PM)Piggy Wrote: Im sorry.......

But....are people REALLY dribbling over a ZT-T v8???!!

Undecided

Dude normally i don't agree with you (normally you just annoy me Wink ) but 100% agreed. Its not a proper Rover! lol
Team Eaton


1999 China Blue 306 GTi6 - Eaton Supercharged - 214.5bhp 181lbft
Reply
Thanks given by:
Haha...maybe this is the start of something special Wink

Its barely a proper car!! Awful barge of a rusty heavy lump of metal on 4 alloys which will corrode into dust with a fire guard for a grill and a pathetic 50 year old puffed out v8 which wasnt much good when it was new!!
Wishes for more power...
Reply
Thanks given by:
Still sounds better than most cars on the road... Good enough reason for me.


I've had to edit the title to move the apostrophe to the correct place, sorry Angel.
Reply
Thanks given by:
Any vids Steve ?
[Image: siggy1.jpg]

the smokey old bus that sounds like a tractor...
Reply
Thanks given by:
Bitch please, dumped for a maccy Ds. Doh Raised rev limiter should be win, or at least will be when you're confident enough in the HG to go looking for it. lol

Another vote against the ZT-T here, they're terrible, lrn2taste.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
(11-07-2014, 06:04 AM)Poodle Wrote: Another vote against the ZT-T here, they're terrible, lrn2taste.

I agree that there are better cars out there, but I have a soft spot for a V8 and at least the MG was sort of British...

The Dodge Challenger I drove in the USA last year was pretty nice if only a V6.
[attachment=17522]
Reply
Thanks given by:
Don't mind the troll, it's all down to personal opinion isn't it. My opinion just happens to be that they're ugly as sin, but then i've heard the same said of me and i'm clearly gorgeous. Wink
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
(10-07-2014, 10:15 PM)Piggy Wrote: Im sorry.......

But....are people REALLY dribbling over a ZT-T v8???!!

Undecided

Yep, and 4.6l with only 260bhp. Have you seen the prices of them though, can get a nice looking diesel estate for a grand, cheapest V8 is nearly 10 grand. There is better (cheaper) RWD V8s say maybe the BMW 540i
Reply
Thanks given by:
theres loads of hugely better options for v8 estates out there.... i would say even the v6 omega estate was better looking and nicer all round!!

Anyway ...back on thread...

Get it wound up steve and bouncing off the limiter...if the HG is good, its good, best find out how good sooner than later!
Wishes for more power...
Reply
Thanks given by:


Forum Jump:


Users browsing this thread: 3 Guest(s)