Gti6 Braking pressure compensator

[BenDturbo1]

Could someone shed some light on this please as not 100% sure, going to change my ph1 non abs drum rear axle (which doesn't have a compensator) to a ph2 gti6 rear axle which has brake pressure compensator to even the braking, would I need to buy all new hoses/pipes for compensator? if so where from? What are the pipes for it called? As been told it's fine to just leave abs off new axle on rear

[C2K]

You should be able to change beams workout disrupting your hydraulics. Check the gti6 forum beam change faq.

[Grant]

The solid brake lines finish in a different place under the car.

When fitting my ph3 beam to my ph 2.5 the lines didn't meet and were short by about 4 inches. You could either make something up to suit, or swap lines over on the beams