Wanted | Heater Matrix hoses

[zx_volcane]

After a set of heater matrix hoses that go into the bulkhead

From an 02 plate hdi


They look different to any I have lying around, the pipes come out at an angle to clear the brake servo, and also it doesn't have a long pipe for bleeding, it just bleeds at the union itself.

[Dangti6]

Do you have a pic of yours?

[mikey b]

How desperate are you for them we are fitting jimbos xud on the 8th and swapping the ones from that to the xud ones

[zx_volcane]

I might be able to get a pic of bits of it, could do with it asap as usual

[zx_volcane]

The plastic bit that goes into the bulkhead does look like this one

How the pipes then go doesn't really matter too much as can make something up

[Dangti6]

I'll get a photo of a set I have this evening. The angle is the same from memory - but has the bleed point on a length of hose. May be compatible.

[zx_volcane]

Sweet cheers!

[HDIkyle]

My hdi ones where like that. So should be easy to get

[zx_volcane]

bump - anyone got a set they can post out or collection near Birmingham?

[Dangti6]

Pic of the one I have:

[Slam Wagon]

Ive got one here. think its missing the bleed cap though, might have a spare i can pop on but ill need to have a hunt for it.

[zx_volcane]

Despite being a later shell, its having an xud transplant

The two pipes - one goes to the back of the block, the other to the back of the head - so as long as they're long enough to reach that far it'll be fine.

Pic of the one I have:

Those will probably be fine - held in by one metal clip through the centre of the hoses? rather than the older style which had a plate that screw over + a metal clip round the outside?

Ive got one here. think its missing the bleed cap though, might have a spare i can pop on but ill need to have a hunt for it.

I can find a bleed cap no worries

[Slam Wagon]

£5 plus postage? I'll try and get it sent tomorrow.

---

Just pop me a pm if you want it