21-12-2018, 02:58 PM
(This post was last modified: 21-12-2018, 03:01 PM by pug306driver.)
New cable is a front line fkc1438.
Have asked about a manually adjustable type cable but they seem not to do one.
Anyone know if a manually adjustable cable is available ???
Anyways an answer to the query of how to unadjust the cable when I have to remove it for a clutch change engine out etc..
First Line Technical Dept
11:25 AM (3 hours ago)
to me
Good morning Richard,
Re setting the cable after fitting is not the easiest thing to do but can be done by pulling inner cable completely out to it`s full length , then while keeping the cable taught pull it back through ( probably need two people ) then put the white cap back on and lock into place. Just make sure when fitting the cable for the first time not to damage the little lugs the cap locks onto.
We unfortunately only have this cable for the application not a manual adjust type.
Hope this helps.
Kind regards.
Roger Nightingale
Hoping the new cable fitting and auto adjust goes like clockwork.
I have 12T press and could make a swage block, to swage an end onto a inner cable, so may have a go at making a manual adjust cable if one is not available.
First things first, getting the pug back on the road for tomorrow.
Have asked about a manually adjustable type cable but they seem not to do one.
Anyone know if a manually adjustable cable is available ???
Anyways an answer to the query of how to unadjust the cable when I have to remove it for a clutch change engine out etc..
First Line Technical Dept
11:25 AM (3 hours ago)
to me
Good morning Richard,
Re setting the cable after fitting is not the easiest thing to do but can be done by pulling inner cable completely out to it`s full length , then while keeping the cable taught pull it back through ( probably need two people ) then put the white cap back on and lock into place. Just make sure when fitting the cable for the first time not to damage the little lugs the cap locks onto.
We unfortunately only have this cable for the application not a manual adjust type.
Hope this helps.
Kind regards.
Roger Nightingale
Hoping the new cable fitting and auto adjust goes like clockwork.
I have 12T press and could make a swage block, to swage an end onto a inner cable, so may have a go at making a manual adjust cable if one is not available.
First things first, getting the pug back on the road for tomorrow.