(30-04-2016, 10:12 AM)mackat Wrote: Always enjoy reading your build process!
Well thank you for those kind words
Baker BM lower fork bush fitted ..already have Vibratechnics hard solid rubber on other end
Welshpug Mei said to drill x3 -3mm hole in the Thermostate to aid bleeding & said its a Peogeot sport trick ...who am I to argue with Mei ..
Baker BM housing fitted picture is upside down sadly
205 Nickle plated hose housing fitted
I don't run a heater so Old top Thermostat matrix pipe blanked off with a 19mm Samco stop end & Clip
Expansion tank fitted & Samco pipes sorted and lower expansion tank goes in to old Matrix pipe behind the engine & that goes to lower Rad hose for filling up also = 19mm
32mm new 205 housing now goes with Baker BM 32mm hose to 205 Nissens rad ....gti6 top hose was 40mm both ends ..
Had to lengthen the 205 Baker BM top hose with 32mm samco straight blue hose
Radiator is connected at the top each side via flat stainless steel plate to two rubber bobbins
You can just see Rubber bobbins in the distance
Just Anti freeze mix & Electric fan & Relay to fit that's controlled via my DTA 40s ..then Bumper on & start finishing off inside the car / dash wiring 3/4 done ready for my full width Fibreglass dash coming later than hoped Tuesday now
Really pleased with baker BM housing
Really pleased with baker BM housing sorry pictures upside down