some help of some person

[pugjohn306]

ADMINS YOU MAY NOW CLOSE PLEASE AS I HAVE DONE IT NO NEED FOR HEAD GASKET YEY...

[Rich306]

I would help if you weren't so far away and I wasn't already busy. Good luck

[Matt]

Chuck aload of bacon on and they will come swarming! I would help mate but I'm
f*cking miles away from civilisation!

[pugjohn306]

Chuck aload of bacon on and they will come swarming! I would help mate but I'm
f*cking miles away from civilisation!

No worrys mate....surely its not that hard well not as hard as the haynes manual makes out...you recon its a 1 man or 2 man job..???

[kentiiboii]

Chuck aload of bacon on and they will come swarming! I would help mate but I'm
f*cking miles away from civilisation!

No worrys mate....surely its not that hard well not as hard as the haynes manual makes out...you recon its a 1 man or 2 man job..???

Id say on the 1.4 its 1 man job. Just maje sure you fit new cam belt water pump while your at it. Also get the head skinned and compression tested.

But what would I know I sold my 1.4 when head gasket went lol

[Rich306]

*skimmed not skinned haha

[Grant]

Drive to me in saaaf London and we can do it. Or is it that un drivable?

[pugjohn306]

Drive to me in saaaf London and we can do it. Or is it that un drivable?

ohhh its drivable lol but no money for fuel however lol....

you tell me if this sounds like a head gasket these are the symptoms i have
1 light blue smoke from exhaust on start up and rev nothing on running well nothing i can see
2 oil seeping from exhaust manifold
that is it i cant see how that could be a head gasket even my spark plugs still look brand new alittle brown ring round the glass part that to me says they have run there course the only other thing i can think it is.is the valve seals on 1 and 3 have gone or my piston rings are going i dont know i dont wanna spend a shed load on a gasket and the effort of fitting it if its not going to cure it i supose i should start with the small things first ey lol

[Grant]

Could be a number of things.

Either a head gasket, or a valve stem seal or oil ring on a piston are the first that i would be looking into.

What engine is it?

[pugjohn306]

Could be a number of things.

Either a head gasket, or a valve stem seal or oil ring on a piston are the first that i would be looking into.

What engine is it?

its a 1.4 mate i have spoken to a few garrages and they all sid check the valve stem seals i tryed to but dont have the tool to push the spring down and pop off the clamps