I started cutting it today Already keen to make progress I lopped one end off. Another 12.50 down the drain Now you can see why I don't like anything that involves custom fabrication. Having said that on my "Exhaust elbow to downpipe" thread it seems like Diggers is running a large radius elbow.
Just reading the thread, the one posts you made in regards to the elbow (other one was a reply to a comment I made):
Nothing specific regarding to radius of the elbow.
Not necessarily, I spoke to Ginge191 who had a GT15 but he said it would be 30 quid in postage alone. Besides I needed the elbow, not the whole thing. Part of the cost is paying for the labour of taking things apart. And as said, elbow has already been cut now, much to your amusement.
Most people in the exhaust elbow thread were of the opinion that the less tight radius elbow would be fine, if you could have posted something contrary at the time that would have been helpful. Here's the thread for reference:
http://306oc.co.uk/forum/thread-16999.html
Edit: Depending on how much it would foul the gear linkages I could always bash it slightly with a hammer to make it clear them.
(21-10-2013, 05:41 PM)Piggy Wrote: if you chop it down...it wont be 90degrees anymore.
and I DID voice this before. But you know better. Im sure you spent the many minutes it took to find a tight bend.
theres turbos on this forum for sale for that very often...and blown ones for nothing
Just reading the thread, the one posts you made in regards to the elbow (other one was a reply to a comment I made):
Quote:I spent probably 10/12hrs on my turbo pipes...
on, off, on, tack, off, weld, on, break off, tack again, refit...repeat. that was for relocation.
but you wana do it right, you need to jig it up.
just get on with it. gee
Nothing specific regarding to radius of the elbow.
(21-10-2013, 05:59 PM)Poodle Wrote: I can see you read the whole thread you made too. You want to try searching a bit harder for bargains some time, i've just got a minty fresh td05 for £36, so daresay i could find a t2 for less.
Go with the tight radius bend or you're going to run into a whole load of issues that you don't need to. At least then you can sell the current elbow and get some money back on it, once you start cutting it's worthless.
Not necessarily, I spoke to Ginge191 who had a GT15 but he said it would be 30 quid in postage alone. Besides I needed the elbow, not the whole thing. Part of the cost is paying for the labour of taking things apart. And as said, elbow has already been cut now, much to your amusement.
Most people in the exhaust elbow thread were of the opinion that the less tight radius elbow would be fine, if you could have posted something contrary at the time that would have been helpful. Here's the thread for reference:
http://306oc.co.uk/forum/thread-16999.html
Edit: Depending on how much it would foul the gear linkages I could always bash it slightly with a hammer to make it clear them.