04-07-2013, 05:58 PM
(04-07-2013, 05:16 PM)Piggy Wrote: use the original gt2052 elbow...slice/cut off the flange and have a new elbow and down pipe with flex made up from that flange
Not sure where to find one? I was hoping to use some standard 3 inch exhaust pipe but I am intrigued by the idea of using the original elbow for it. I have searched eGay for "Garrett gt2052 exhaust elbow" but it shows exhaust elbows for Renault 5 turbos!
Searched for "Garrett exhaust elbow" as well but none of them are the right fit.
(04-07-2013, 05:17 PM)Dum-Dum Wrote: Again make a plate for it then get a 3" 90* elbow welded on or even better a 3" V-band connector so you can get the angle perfect on the car.
That is a really good idea about the V clamp! Thank you.