03-07-2013, 09:33 AM
Good work mate,
Havent had chance to read all the posts in full so not sure if you are already planning to, but if I was you, id put them counter sunkbolts in, and weld them all / grind back flush, so there effectivly just studs welded to the plate then, will make it stronger, and stop the damn things from spinning! Can put together in any oder then, whats what ive always done anyway
Dont forget to use some exhaust paste either on each surface
Good job though so far
Havent had chance to read all the posts in full so not sure if you are already planning to, but if I was you, id put them counter sunkbolts in, and weld them all / grind back flush, so there effectivly just studs welded to the plate then, will make it stronger, and stop the damn things from spinning! Can put together in any oder then, whats what ive always done anyway
Dont forget to use some exhaust paste either on each surface
Good job though so far
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
| #DervMafia |