Leaky union

[Matt]

I've got a leaky Union on my rear brakes after knocking up some new lines. What are options, it's not pissing out, it's not even dropped yet, I can see it's a little wet it's as tight as it will get, what are my options, guess its go back and start again? Or will this hold?

[Poodle]

If you've made new lines can you not just chop the dodgy join off, make a new flare with union and adjust the line to fit..?

[daddyfixit]

its not right, so make up a new pipe and make sure flares look even or you are wasting your time.

[Toms306]

What are you expecting the options to be other than tightening it or replacing it? Can't really bodge it with tape or cable ties.

[Matt]

I don't mind doing it again, just wondered if a small wearing would effect the braking system tbh, I was tired when I wrote this so not thinking straight as per

I'll remove the leaky one and make new flares no problem