Repairing rear axle and camber?

[JTaylor2005]

I have had rear camber on my 306 now since I bought it. Never even knew that it was an issue tbf and certainly didn't know it was caused by the whole rear beam when I bought the car..

Anyways I wannt get it sorted. I presume I can just get this axle and get it fitted yeah?

http://www.imaxle.co.uk/306-hatch-disc-with-abs

Would there be anything else that needs replacing as well which that beam to make it all fit and work?

Any info with this would be much appreciated

Thanks
Jack

[craig306]

http://306oc.co.uk/forum/showthread.php?tid=28869

have a read here, this guys dose them too.

[JTaylor2005]

Cheers. Looked into his stuff he don't do fitting I don't think.

[Toms306]

It's 4 bolts....fitting isn't really an issue!

[JTaylor2005]

It's 4 bolts a fair few jacks, brake pipes, handbrake cable, rusty and seized bolts, etc etc and on a gravel drive without the right tools :/ lol

[Toms306]

Sounds familiar...




Honestly it's really not that bad...even I managed it.

[welshpug]

6 nuts, not bolts.

plus rusty brake lines rusty exhausts and abs wires and handbrake cables.

[miles]

New tube, Still want to know how this is, RRP from Pug is £363.00, But fitting as said is the worst part, Rust, Brake Lines and Callipers can all be a pain so be prepared