Posts: 2,140
Threads: 128
Joined: May 2014
Reputation:
21
Location: Cardiff
Car Model/Spec: Stage3 HDi RHF5@25psi 174bhp
Thanks: 1
Given 41 thank(s) in 38 post(s)
07-07-2014, 10:48 PM
so i am leaning more and more to a small crack opening up in my cylinder head somewhere...
inflated coolant lines (hard but not too hard) and when reved i get foam in me coolant expansion tank
however, how much cavitation does the pump cause as its coming from the return line from the pump and is most apparent when its hot (only when its hot) and the thermostat is open...
any ideas?
i am guessing someone could have a poke at pugfest and identify it for me/confirm or deny my fears so to speak.
Given the choice between Niall and the sheep. I would choose the sheep!
/Toseland
Posts: 1,833
Threads: 91
Joined: Dec 2011
Reputation:
12
Location: Wrexham
Car Model/Spec: 306 D Turbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
Any other head symptoms, high running temps, using coolant, mayo, etc.
Supercharged XUD Project - Dead
Posts: 2,140
Threads: 128
Joined: May 2014
Reputation:
21
Location: Cardiff
Car Model/Spec: Stage3 HDi RHF5@25psi 174bhp
Thanks: 1
Given 41 thank(s) in 38 post(s)
Nope, lol, hence i asked about the cavitation..
although not accurate by any stretch of the imagination, the coolant guage sits bang middle of the range as normal..
Given the choice between Niall and the sheep. I would choose the sheep!
/Toseland
Posts: 20,092
Threads: 591
Joined: Nov 2012
Reputation:
54
Location: Cotswolds
Car Model/Spec: Stage 13 16v HDi
Thanks: 22
Given 68 thank(s) in 68 post(s)
HG failure could do that.
have you had the gasses in the coolant sniffed?
When you give it a good boosted drive, does it not get hot then?....heaters working ok? Not losing coolant?
Posts: 5,205
Threads: 91
Joined: Dec 2011
Reputation:
83
Location: Oxfordshire/Cornwall
Car Model/Spec: Moonstone DT/Volvo V50
Thanks: 2
Given 41 thank(s) in 41 post(s)
Probably HG failure - just like mine was, XUDs rarely mayo their oil/coolant unless they're very severe.
(16-05-2016, 10:45 AM)Toms306 Wrote: Oh I don't care about the stripped threads lol, that's easily solved by hammering the bolt in.  Nanstone GTD5 GT17S - XUD9TE
Volvo V50 D5 R-Design SE Sport - Daily cruise wagon.
Posts: 2,140
Threads: 128
Joined: May 2014
Reputation:
21
Location: Cardiff
Car Model/Spec: Stage3 HDi RHF5@25psi 174bhp
Thanks: 1
Given 41 thank(s) in 38 post(s)
HEad gasket is new, brand new.. and VR one as well.. 3+1+1 repair gasket, head skimmed, sorted..
Given the choice between Niall and the sheep. I would choose the sheep!
/Toseland
Posts: 1,791
Threads: 19
Joined: Jun 2012
Reputation:
12
Location: Devonshire
Car Model/Spec: Peugeot 309 GRD(T)
Thanks: 4
Given 25 thank(s) in 24 post(s)
didn't you just re-torque and drash on ruan?
Posts: 20,092
Threads: 591
Joined: Nov 2012
Reputation:
54
Location: Cotswolds
Car Model/Spec: Stage 13 16v HDi
Thanks: 22
Given 68 thank(s) in 68 post(s)
(08-07-2014, 09:55 PM)toseland Wrote: HEad gasket is new, brand new.. and VR one as well.. 3+1+1 repair gasket, head skimmed, sorted..
did you have the same symptoms before?
If it was skimmed, it should have been pressure tested
Posts: 2,140
Threads: 128
Joined: May 2014
Reputation:
21
Location: Cardiff
Car Model/Spec: Stage3 HDi RHF5@25psi 174bhp
Thanks: 1
Given 41 thank(s) in 38 post(s)
09-07-2014, 09:31 PM
(This post was last modified: 09-07-2014, 09:34 PM by toseland.)
It was Mr Piggy... it came back fine, no loss on any cylinder and the bores all looked pristine (still see the hone marks)
i had a gas test done on the header tank today.. nothing in the way of exhaust gases present... he was drawing through the blue liquid for a few minutes whilst reving and also whilst idling..
so the bubbles must be cavitation in the pump, and/or just turbulance in the pot itself.. i am at a loss to explain the inflated hoses tho.. maybe the header tank cap is a little too tight?
Given the choice between Niall and the sheep. I would choose the sheep!
/Toseland
Posts: 1,833
Threads: 91
Joined: Dec 2011
Reputation:
12
Location: Wrexham
Car Model/Spec: 306 D Turbo
Thanks: 0
Given 0 thank(s) in 0 post(s)
Any loss of coolant at all? And when you say temp sits in the middle of the range does that mean 90*??
Supercharged XUD Project - Dead
Posts: 1,441
Threads: 48
Joined: Dec 2011
Reputation:
5
Location: Woodstock, Oxford
Car Model/Spec: Peugeot 306 S16 Cossack
Thanks: 9
Given 2 thank(s) in 2 post(s)
Sounds very much like my ZX. Unexplainable after 2 years and 60 odd thousand miles
Peugeot 206 GTI HDI
Volvo V50 2.0d
Volvo XC90 D5
Posts: 3,662
Threads: 127
Joined: Feb 2012
Reputation:
33
Location: London
Car Model/Spec: ZX Volcane TD
Thanks: 6
Given 32 thank(s) in 32 post(s)
Ahhh yeah Anton's mystery Zx, throwing up its water, never got to the bottom of that
Posts: 20,092
Threads: 591
Joined: Nov 2012
Reputation:
54
Location: Cotswolds
Car Model/Spec: Stage 13 16v HDi
Thanks: 22
Given 68 thank(s) in 68 post(s)
10-07-2014, 10:53 PM
(This post was last modified: 10-07-2014, 10:54 PM by Piggy.)
My unc had a xantia that did that.
Had head done twice, tested and tested. Found some info that a spate of heads werent much cop. You can find them by the code on the head. Code is the drill holes, or lack of, above the glow plugs. Cant remember what number the dodgy head batch was though
|