Tyre pressures, What do you put in?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tyre pressures, What do you put in?
#1
How much psi's do you use? Also do you do them when warm or cold as possible?
Doesnt even own a 306.
Reply
Thanks given by:
#2
cold as possile, usually around the 38-40psi mark, otherwise i find car feels boaty
Reply
Thanks given by:
#3
36 front, 34 back.
GT2052s DTurbo
OEM+ HDI Estate
Project thread
Reply
Thanks given by:
#4
38psi

235/35/19's
Reply
Thanks given by:
#5
Didnt realise everyone puts so much in! Hopefully some more will comment and get more opinions! Smile
Doesnt even own a 306.
Reply
Thanks given by:
#6
Depends what tyre you have...
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |

[Image: sigi-2.png]
Reply
Thanks given by:
#7
^^^^^this! huge differences!
Wishes for more power...
Reply
Thanks given by:
#8
35PSI front, 34PSI rear - 195/50/15 (speedlines) on the 205 (might be 45's, can't remember).
36PSI front, 36PSI rear - 195/55/15 (cyclones) on the 306.
Supercharged GTi6 Build
S14 Zenki Build
[Image: signature.png]
Reply
Thanks given by:
#9
Im keen to know what everyone uses really, im sure it'll be of use to other members to know what certain people put in there tyres.
Doesnt even own a 306.
Reply
Thanks given by:
#10
Well I would use more than I do now if I was on 15's with floppy sidewalls, but i'm on 45 profile 16's which are extra load so are hard enough not to need a lot of pressure.
GT2052s DTurbo
OEM+ HDI Estate
Project thread
Reply
Thanks given by:
#11
I used to put 50psi on my clones. Lawl the car would float :o
Reply
Thanks given by:
#12
On the 'clones, 36PSI all round. However, as the nearest tyre machine is 15 miles away I can never do the pressures properly cold. I do usually do it at sainsburys though, after shopping, so hopefully the tyres have cooled a bit by then!
Reply
Thanks given by:
#13
I put 36 all round but have started doing 38 up front 36 at back ThumbsUp
[Image: ForumSignature.jpg]
Reply
Thanks given by:
#14
195/50/15s...

34psi all round
Wishes for more power...
Reply
Thanks given by:
#15
with the tyres on there now, my tyre fitter put in 32 all round..
Diablo Hdi Dturbo and 205 1.9 project - it lives!
Reply
Thanks given by:
#16
^tyre fitters usually do that to be on the safe side tbh, if im filling someones tyres at work for them thats what i go too, you wont go wrong, tyre wont go down and you wont explode tyre.
Its all down to personal preference really, i feel putting about 40 in gives me much better feel when driving.
Reply
Thanks given by:
#17
40 is nuts...you'll wear the centres out in no time...must be rock hard too Undecided
Wishes for more power...
Reply
Thanks given by:
#18
35 fr 195/55/15
32 rear
Reply
Thanks given by:
#19
I do 32 all round. 195/50r/16
Hdi decat midlebox mod soon to be stage1Itwasntme
Reply
Thanks given by:
#20
36 all round. 205/40/17
Supercharged XUD Project - Dead

HDi Cabby Project Click
Reply
Thanks given by:
#21
35 or so, as long as they're all the same and they're properly up to profile, you'll be OK. Might stick a bit more in and see how it feels.
Welding and fabrication projects undertaken, contact me for more information.

Reply
Thanks given by:
#22
i find it better to put high pressure in when going on motorways to reduce dragging the tyres, but i hover around average (33psi) on normal town so i dont feel everybump
Reply
Thanks given by:
#23
What pressure do people run challengers on?
Reply
Thanks given by:
#24
I'm on clones running 195 50 with Nexen all weather up front and prada spec 2s at the arse end and I usually put 32-34 depending if the tyres hot or cold.
Reply
Thanks given by:
#25
I've just brought a set of Gti-6 cyclones which have 195/50/15 tyres, as these aren't a standard Peugeot size, what tyre pressures would you put in? I was recommended to put in 32/33psi in. Whats best for day to day driving?
Provence blue - Fixer upper   Blush 

 Mk3 306, 2.0 litre HDi
Reply
Thanks given by:
#26
I tend to run my HDi at about 35-40. (195/55R15) usually cos i have stuff in the boot.
It goes, it stops (as reqd). Makeup
Hate Housework!
Reply
Thanks given by:
#27
Similar to the previous posts, I stick in 36psi all round on Cyclones with 195/50R15 Pilot sport 3's.

Used to put in 38 when I first got the tyres but its mega uncomfortable on bumpy surrey roads.
Reply
Thanks given by:
#28
Depends what tyres you're using and model and engine combo. So a gti6 or hdi hatch on 195/50/15 should be 35f 33r iirc. Make it an estate and the rear pressure needs to be brought up to match the front. Put a load of weight in the back and you'll want the fronts up a couple of psi ans the rears up to 38-40.

Basically less body/engine weight needs less pressure and vice versa. Same goes for tyre profile, lower profile tyres will need a bit more pressure. So a gti6 on 17s will want to be running about 37f 35r. If the tyres are extra load rated (harder sidewalls) you want to knock off a couple of psi. Runflats go down a couple more psi again.

I personally run 80 profiles on 14"s on an estate at 32psi all round. This is all based on what i've seen at work with manufacturers specifying tyre pressures for all sorts of different vehicles.
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:
#29
Christ! 34psi+ is silly in a 306

32F 30R
in our 306 hdi 195/50/15
90' 205 gti6 supercharged
05' Evo 9 IX GT

Team eaton.


Axle rebuilds please contact me for your needs.

https://www.facebook.com/axlesbystef/
Reply
Thanks given by:
#30
I didn't remember correctly lol, hdi hatch should be 33 all round on 195/55/15 according to Autodata (who will have taken their data from Peugeot).
306 HDi Deathtrap - 130bhp / 220lbft
...UPGRADING...



Reply
Thanks given by:


Possibly Related Threads…
Thread Author Replies Views Last Post
  Tyre Pressures? JTaylor2005 8 1,997 19-10-2015, 05:37 PM
Last Post: Piggy
  stretched tyres pressures rd070707 5 2,150 26-04-2013, 09:48 AM
Last Post: Slam Wagon

Forum Jump:


Users browsing this thread: 4 Guest(s)