13-12-2011, 08:07 PM
Shh up about 106's and 1.5 TU nads in here please! lol
Right manifolds are here, had to tweak a bit, but they do fit, need to get them skimmed as there not flat from welding warpage... but im going to go ahead and get it on, to make sure there arnt any other issues..
So started by heatwrapping it...well i say I....tbh i did one bit, got bord / pissed off, and James (cromptons) took over, and did all the rest for me, so +1 here thanks James
Then started to fit it / mock up fit anyway to test things...
Need to rotate compressor on this like i did before behind the engine, and work on a few other parts of it to get it correct...
As already said, James was here today along with dave (Ha11)
Right manifolds are here, had to tweak a bit, but they do fit, need to get them skimmed as there not flat from welding warpage... but im going to go ahead and get it on, to make sure there arnt any other issues..
So started by heatwrapping it...well i say I....tbh i did one bit, got bord / pissed off, and James (cromptons) took over, and did all the rest for me, so +1 here thanks James
Then started to fit it / mock up fit anyway to test things...
Need to rotate compressor on this like i did before behind the engine, and work on a few other parts of it to get it correct...
As already said, James was here today along with dave (Ha11)
| Dyno Power Runs & Steady State Facilities Available, Just Ask Anytime |
| #DervMafia |
| #DervMafia |