(12-03-2017, 08:49 PM)madmadmax Wrote: moste likley will be the clutch switch so get it working as it effects fueling in some situationsAha! I think you're right, as per this diagram. Just got to figure out where it goes now, think its at the very top of the clutch arm.
(12-03-2017, 09:34 PM)Eeyore Wrote: Sorry haven't got a photo I can upload from mobile but there are some on my project thread probably a few pages back.No worries, will try to have a look for it.
Yesterday I managed to remove the rear carpet and the foam underneath followed by the front carpet which was harder as it was caught up around the centre console. I ended up cheated and took the stanley knife to the last but as I had no clue what it was snagged on and I'd had enough of having my head in the footwell as the carpet smelt pretty rotten. Once I took out the carpet I found the foam underneath was a little mouldy. As Saturday was sunny I left both sets of foam underlay in the sun to absorb some rays.
Rear seats and carpet out...
Working out the front carpet!
Both sets out...
Foam drying in the sun
In between trying to wrestle the carpet out I went round and took off all the rubber trims. As you can imagine there was a lot of grime underneath which I set about removing.
Once the carpets were out it was time for the RugDoctor!
In progress. It took ages to get them clean, the hand tool attachment sprays cleaning fluid onto the carpets and there is a little brush on the back to move apart the fibres so the vacuum can suck up the soap/dirt.
I don't have many after shots as it was getting dark but what came out was impressive.
190k Moonstone 3dr HDI sold
..on the lookout for a 6/rallye
..on the lookout for a 6/rallye