03-06-2012, 08:28 AM
Just a quick thread for now, in preparation for FCS. Don't know if anyone was following it on pug306.
As it stands now, the engine is running but I have slight head gasket issues but still going to risk it down to Fcs and then a rebuild will be on the cards when I get back. So even if I end up going home on a low loader I ain't that fussed!
Recent pic
![[Image: d49f67d2-1053-d12d.jpg]](http://img.tapatalk.com/d49f67d2-1053-d12d.jpg)
![[Image: d49f67d2-105e-c7e6.jpg]](http://img.tapatalk.com/d49f67d2-105e-c7e6.jpg)
Still to do before FCS
Seats and cage to weld in
MOT
Rear beam to lower substantially.
Spec at moment
Standard rod thrower spec engine
T25 hybrid
9mm Bosch
Oil cooler
Home brew air intake
An exhaust of sort
Tmic
Stripped out buckets and cage
247mm front brakes and refurbed drums at the back. Ha
Anyway spare block will be getting done after Fcs with hdi rods bit of lightening skimming etc, brand new head, decent clutch and fmic. And more than likely 11mm
See you all at Fcs!
As it stands now, the engine is running but I have slight head gasket issues but still going to risk it down to Fcs and then a rebuild will be on the cards when I get back. So even if I end up going home on a low loader I ain't that fussed!
Recent pic
Still to do before FCS
Seats and cage to weld in
MOT
Rear beam to lower substantially.
Spec at moment
Standard rod thrower spec engine
T25 hybrid
9mm Bosch
Oil cooler
Home brew air intake
An exhaust of sort
Tmic
Stripped out buckets and cage
247mm front brakes and refurbed drums at the back. Ha
Anyway spare block will be getting done after Fcs with hdi rods bit of lightening skimming etc, brand new head, decent clutch and fmic. And more than likely 11mm
See you all at Fcs!