Sigma 5dr 1.9 XUD Project Dyno Results Included

[c.gerrard]

I finally got round to picking up my 306 earlier this week.

It's an R reg, 1.9 TD on 67,817 miles and everything is completely standard, even the brakes unfortunately, as it would be nice to actually stop.

There are scratches here there and everywhere, so will probably need a total re-spray at some point. Will also need to change the seats, think they are a bit of a bio-hazard at the minute. Only cause for concern at the minute is someone decided to take it off roading and has buggered the sump, which is leaking through two bolts as far as i can tell. Should have replacement by this weekend though.

Plans for it:

Bosch pump (once its gov moded)
Fit re-furbed cyclones (will be running them on Proxes)
Graphite masked headlights
GTI brakes
40mm springs
Spoiler
Side skirts
Boost gauge
De-badge
De-wiper

It's a project that aint exactly pushing the boundries, just restoring a perfectly good car..... to full health. I would like to get the majority of it done before FCS, but I think everyone is in the same boat!


[attachment=0]
[attachment=5]
[attachment=4]
[attachment=3]
[attachment=2]
[attachment=1]