Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ph1 and ph2 engine loom connector differences
#19
(15-06-2020, 12:27 PM)Mighty306 Wrote: Same goes for sensors. Ideally go for same as original, or best quality aftermarket. The cheap ones are likely to make the car run worse not better. (Learned that lesson quite a few years ago). Original MAP & TPS were Bosch. Not sure about coolant temp.

Re the injectors, where have you purchased them from? Mr Auto were selling off some original Bosch ones quite cheap a while back, but even then not at the €20 mark.

I try to always get parts from Bosch, Valeo etc., manufacturers that I know and trust. The injectors, fuel pressure regulator and MAP I ordered are all Bosch. TPS is Delphi and temp sensor Valeo. I've been ordering my spares from this Estonian store. Prices are good and they deliver quickly to Finland. Don't know if they deliver elsewhere in Europe, but at least they don't seem to have English language available on their site. I've used autodoc previously, but too often the parts are NOT from the manufacturer I've ordered them from, and they are so slow to deliver.

edit: Ok the injectors were not 20€ a piece, they were 21,32€ a piece Smile
Reply
Thanks given by:


Messages In This Thread
RE: ph1 and ph2 engine loom connector differences - by jirupa - 15-06-2020, 12:49 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Seatbelt tensioner connector tigerstyle 2 1,571 17-03-2017, 12:07 PM
Last Post: Mattcheese31
  Engine loom fire roger352 4 2,445 14-07-2016, 08:12 PM
Last Post: zx_volcane
  GTi6 Engine loom help MCH 9 5,850 03-06-2016, 03:47 PM
Last Post: MCH

Forum Jump:


Users browsing this thread: 1 Guest(s)